Advertisement
Tigertop™ – Installation Instructions
Install Rear Corner Studs
To ensure a good fi t, have one person pull down
on the rear bow while the other person pulls the
fabric down and to the rear to locate the rear corner
studs. When you are satisfi ed with the tightness
of the top, press the snaps against the body. The
chalk will leave marks for the Body Stud locations.
The Threaded Body Studs should be 1/4 inch be-
low the top lip of the body. Center punch the marks
and drill 3/16 inch holes at the marked locations on
each rear corner. Install a Body Stud and Hex Nut
in the rear corners. Snap the top to the corner body
studs.
Threaded
Body Stud
Outside
Rev. E 0207
Install Remaining Studs
Install the remaining Threaded
Body Studs on the Side Pan-
els and the Tailgate. Alternate
from side to side as you install
the studs and snap the top to
Install Rear
each new stud. This will keep
Corner Studs
the tension of the top evenly
spread.
Side Wall
Threaded
Body Stud
Hex Nut
Inside
Side Wall
Outside
Hex Nut
Inside
Secure Buckle Straps
Thread the buckle strap assembly through each
Footman Loop and then back through the buckle.
Do not over tighten.
Install Self-Adhesive Hook Strip
Wrap the fabric fl aps, sewn to the top above and
behind the doors, around the Horizontal and
Vertical Assemblies and fasten the hook and loop
fasteners. Cut the PSA Hook in half and assemble
the PSA Hook on the bevel of the vehicle, where
the two side curtains zip together.
The weather strip in the vertical
fl ap should lay to the outside of
the Vertical Assembly.
Hex Nut
Threaded
Body Stud
51443 pg. 7
Advertisement
