Table of Contents
Advertisement
Intelligent Valve Monitor
Mounting on the Pneumatic Actuator - Actuator with Open/ Closed Local Signaling:
1 - Mount the local indicator on the
actuator shaft , inserting the spacers
as needed , according to the height
axis.
4 - The indicator allows the adjustment
of the Open / Close position indication
according to the actuator type (NO /
NC) . Adjust the local indicator
according your application and then
tighten the fixing screw.
Montagem no Atuador - Acionador com Sinalização Visual por Cores:
1 - Mount the local indicator on the
actuator shaft , inserting the spacers
as needed , according to the height
axis.
4 - Now place the monitor on the
actuator , then the two M5 screws and
tighten with a proper key.
Sense
2 - Place the M6 screw for fixing the
local indicator to the actuator shaft
and tighten it with a proper key but do
not overtighten in order to enable the
adjustment of the triggers.
5 - Now place the monitor on the
actuator.
2 - The trigger must be positioned in
order to sensor 1 activated together
with solenoid command. Observe the
rotary direction of the actuator.
5 - Install the black cover on the trigger
fixing screw. Also Install the green and
blue covers for indicate de open and
close position of the valve.
3 - Mandatorily sensor 1 must be
triggered together with the solenoid
command. For this , adjust the local
indicator turning -o with a hand,
always observing the rotary direction
of the actuator.
6 - Place the acrylic on the trigger ,
then the two M5 screws and tighten
with a proper key, but do not
overtightening to avoid damaging the
acrylic.
3 - Place the M6 screw for fixing the
local indicator to the actuator shaft
and tighten it with a proper key
6 - The pictures below illustrate the
open and closed position of the valve.
7
Advertisement
Table of Contents
