Summary of Contents for Sense PSH5-M32-ASI3.2S-Ex
-
Page 1: Installation Recommendations
INSTRUCTIONS MANUAL Installation Recommendations Intelligent Valve Monitor PSH5-M32-ASI3.2S-Ex... - Page 2 1 detects only the magnet with north pole and sensor 2 only detects the magnet with the south pole, thus avoiding inverted detection. Sense...
- Page 3 OPEN CLOSED Acionador Espaçadores Adicionais 10mm Espaçador Eixo do Atuador Sense...
- Page 4 8 - We also recommend the use of pre-insulated terminals at the ends of the wires, to avoid problems of poor contact or short circuit. Alicate ZA3 Sense...
- Page 5 17 - Tighten the cable glands, plug the sensor in the terminal box and tighten the two screws. 12 - Insert the cables through the cable gland holes and mount them but do not overtighten. 13 - Fasten the wires to the terminals, observing the connection diagram. Sense...
- Page 6 01 - Place the magnet on the actuator on the top face marked inside. 02 - Place the magnet on the bottom of the actuator face checked out. 03 - Mount the metal cover over the magnet in your accommodation. 04 - Fold tabs for fixing the metal cover. Dobra Sense...
- Page 7 , then the two M5 screws and fixing screw. Also Install the green and open and closed position of the valve. tighten with a proper key. blue covers for indicate de open and close position of the valve. Sense...
-
Page 8: Dip Switch
Notes: - Case: 0000xxxx ou xxxx0000 => Disables intelligence function automatically. - "1" - switches on ON. / "0" - switches on OFF. Possible causes for failure indication are: - Stuck valve - valve with high air leakage. Sense... -
Page 9: Input Bits
Energy Savings and Solenoid Increased Life Span: If the solenoid remains activated for more than 1 minute and 30 seconds, the sensor will automatically reduce its energy-saving voltage source and increasing the life of the solenoid. Sense... -
Page 10: Signalling Led
Solenoid Valve: For the solenoid valve to be safely connected to the valve sensor, it must be certified as Intrinsic Safety. Sense offers sensors along with the solenoid valve, both certificates for use in potentially explosive atmospheres. The valve body meets the Namur standard, which does not require fixing accesories, as it is mounted directly on the pneumatic actuator. -
Page 11: Technical Characteristics
Intelligent Valve Monitor Technical Characteristics: Data PSH5-M32-ASI3.2S-Ex Sensor Distance 5 mm Operating Distance 5 mm Standard Target 9 x 9 mm Hysteresis < 3º Repeatability < 1º Supply voltage 30.5 Vdc via AS-Interface network Ripple Consumption current < 40 mA... - Page 12 Rua Tuiuti, 1237 - Tatuapé - 03081-000 - São Paulo - SP - Fone: (11) 2145-0444 - Fax: (11) 2145-0404 - e-mail: vendas@sense.com.br - www.sense.com.br We reserve the right to modify the information contained herein without notice...