Sense PSH5-M32-ASI3.2S-Ex Instruction Manual page 5

Intelligent Valve Monitor
9 - The output cable network must be installed on the
cable gland 2. Repeat steps 6, 7 and 8 for this new
cable.
10 - The solenoid cable should be installed in cable
gland 3. Repeat steps 6, 7 and 8 for the cable. If the
solenoid is not used, replace the cable gland PG9 for a
buffer. Follow the steps below:
10.1 - Remove the cable gland # 3 with the help of a
19mm hex wrench.
10.2 - Put the plug provided with the kit terminal and
tighten with a screwdriver and wide slot.
11 - With all prepared cables, insert the nut of the
cable gland and the rubber seal on the cables that will
be used.
12 - Insert the cables through the cable gland holes
and mount them but do not overtighten.
13 - Fasten the wires to the terminals, observing the
connection diagram.
Sense
14 - Push the connector into the junction box, help
pulling cables.
15 - Put the connector cover, if necessary move the
cables so that the cover can be fitted.
16 - Tighten the three screws securing the connector
cover.
17 - Tighten the cable glands, plug the sensor in the
terminal box and tighten the two screws.
5