Advertisement
There are four buttons and an LCD on the panel of DigiCopier III.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.
Connecting the power cable and turning on the DigiCopier III
a. Connect the power cord provided from the wall outlet to the back of the DigiCopier III
b. The power switch is located on the front of the tower.
Steps for the Copying Process (Note: may not able to copy-protected DVD or CD.)
1. Turn on the DigiCopier III by pressing the power switch.
2. Insert media you wish to duplicate into the source tray on the top.
3. Populate the destination trays with blank CDs or DVD media. A rewritable DVD or
CD containing old data can also be used, but the old data will be automatically
erased.
4. After the DVD writers detect the media, press ENT to start copying.
www.addonics.com
Front view
Technical Support (M-F 8:30am - 5:00pm PST)
Rear view
LCD will display the copying information similar to the following:
Copy
X3
4400M
97%
4367M
When copying is in progress, MB and time will decrease while the percentage of completion
will increase. "M" means the size of data that you want to copy.
When copying comes to an end, the DVDs copied successfully will be ejected automatically.
The LCD then display the information similar to the following:
Result:
Pass 3
Fail 0
The complete user manual of the DVD Duplicator can be found in the included CD or can be
downloaded from the product web page
http://www.addonics.com/products/dgc3.php#tabs-5
Phone: 408-453-6212
Email. www. Addonics.com/support/query/
Advertisement
