Table of Contents
Advertisement
CALLER ID FEATURES
Reviewing Caller ID list
As calls are received and stored, the Caller ID list is updated to let you
know how many calls have been received.
1. Press CID/VOL
to scroll through the Caller ID list from the most
recent to the oldest.
2. Press CID/VOL
to scroll through the Caller ID list from the oldest
to the most recent.
3. Press TONE/EXIT to return to Standby Mode anytime.
Note: 1. If area code is programmed (for example 416), the whole
number (416-2225555) including area code will be shown on the
screen during a call coming from this area. When reviewed later, the
area code will not be shown (i.e. LCD shows 2225555 only). 2.
You may also transfer Caller ID entries to the directory.
See Storing caller ID entries in directory below.
Format Caller ID numbers
The MUTE/FORMAT key lets you select how many digits of the number
are displayed.
Press MUTE/FORMAT once to add the area code (Note: The
•
programmed area code must match the Caller ID area code).
Press MUTE/FORMAT again to add 1 plus the area code.
•
Press MUTE/FORMAT a third time to go back to the 7-digit number.
•
Storing Caller ID entries in the directory
Before storing a caller ID number, make sure the number appears in
proper digits for your dialing area. If not, change it using the MUTE/
FORMAT key. For example, if the Caller ID number appears 1-416-222-
5555 but it is not a long distance number, press MUTE/FORMAT until it
shows 416-222-5555 (without 1).
Note: If a specific memory entry is longer than 15 digits, the last 15
digits show on the screen.
17
Advertisement
Table of Contents
