Table of Contents
Advertisement
TECHNICAL INFORMATION
REN Number:
The Ringer Equivalence Number (REN)
assigned to each terminal's device
provides an indication of the maximum
number of terminals allowed to be
connected to a telephone interface.
The REN number of this phone is
located on the bottom of the base unit.
The termination on an interface may
consist of any combination of device
subject only to the requirement that the
sum of the Ringer Equivalence Numbers
of all the devices does not exceed 5.
CAUTION
This product is intended for use in
CANADA only. Sale or use in other
countries may violate local laws.
Cordless telephones use radio
frequencies to allow mobility. This
affects the performance of your phone.
1. NOISE
Electrical pulse noise is present in most
homes at one time or another. This is
most intense during electrical storms.
Certain kinds of electrical equipment,
such as light dimmers, fluorescent
bulbs, motors, fans, etc., also generate
pulse noise.
Because radio frequencies are
susceptible to this, you may on
occasion hear pulse noise through the
handset. This is usually only a minor
annoyance and should not be inter-
preted as a defect of the phone.
2. RANGE
Because radio frequencies are used, the
location of the base station can affect
the operating range of the phone. Try
several locations and choose the one
that gives the clearest signal to the
handset. (Turning in a circle while
holding the handset may also increase
the operating range.)
3. INTERFERENCE
Electronic circuits activate a relay to
connect the unit to your telephone line.
These electronic circuits operate in the
radio frequency spectrum. While
several protection circuits are used to
prevent unwanted signals, there may
be periods when these unwanted
signals enter the base station. You may
hear a click or hear the relay activate
when you are not using the cordless
handset. If this occurs frequently, you
can minimize or eliminate the problem
by lowering the height of the base
station or relocating the base station. It
may also be helpful to change the
operating channel and/or the security
code setting.
Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
NOTICE:
Privacy of communications may not be
ensured when using this telephone.
Other devices, including other cordless
telephones, may interfere with the
operation of this cordless telephone or
cause noise during operation. Units
without coded access may be
accessed by other radio communication
systems. Cordless telephones must not
cause interference to any licensed radio
service.
The Industry Canada Label identifies
certified equipment. This certification
means that the equipment meets
certain telecommunications network
protective, operational and safety
requirements. The ministry does not
guarantee that the equipment will
operate to the user's satisfaction.
Before installing this equipment, users
should ensure that it is permissible to
be connected to the facilities of the
local telecommunications company.
The equipment must also be installed
31
Advertisement
Table of Contents
