Siemens SpeedStream 6515 Safety Manual

Safety and Certifications
Important Information about the SpeedStream 6520, SpeedStream 6515:
Installation and Safe Usage Instructions:
1. Place the SpeedStream ADSL gateway in an upright horizontal orientation on a flat
surface.
2. Connect the manufacturer supplied AC to DC power adapter. The SpeedStream 6xxx
series gateways require the use of a 12 VDC, 1 A power adapter. Only use a manufacturer
supplied and approved power adapter.
3. Connect the Ethernet cable (provided) to the RJ45 port on the SpeedStream ADSL
Gateway labeled "Ethernet". Then connect the other end of the Ethernet Cable then to the
Ethernet port of a computer. Repeat as necessary for the available Ethernet ports.
4. If a USB port is available, connect the "B" end of the provided USB cable to the port on
the SpeedStream ADSL Gateway labeled "USB". Then connect the "A" end of the USB
Cable to the USB host port of a computer.
5. Connect the provided DSL Cable to the port on the SpeedStream ADSL Gateway labeled
"DSL". Connect the other end of the DSL Cable to a standard Phone Jack. Always use a
DSL cable with a minimum wire gauge of 26AWG.
6. If using a USB port, use the SpeedStream CD to configure the computer's USB
connection.
When using this device, basic safety precautions should always be followed to reduce the
risk of fire, electric shock, and injury to persons including the following:
1. Do not use this product near water and avoid contact with moisture. For example, do not
use near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a
swimming pool. Care should be taken so that liquids are not spilled on this equipment.
2. Never insert objects into the vents of this equipment as this can result in the risk of
electrical shock or fire.
3. This equipment should only be operated from the type of power supply indicated on the
marking label.
4. Do not overload wall outlets or extension cords. Doing so can result in the risk of fire or
electrical shock.
5. Avoid blocking any vent openings or exhaust exits on this equipment. Do not place
equipment in a built-in installation such as a cabinet that may impede the flow of air through
the ventilation openings.
6. The equipment should be situated away from heat sources such as radiators, heat
registers, stoves, or other heat producing appliances and equipment.
7. Care should be taken to ensure that the power cord is routed, so it is not likely to be
walked on or pinched by items placed upon or next to it.
8. Unplug this equipment before cleaning. Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning only.
9. This equipment is not user serviceable and is to be serviced by qualified personnel only.
Do not disassemble this equipment. If service is required, disconnect all power and phones
lines from the equipment and consult qualified service personnel.
Save these Instructions!
Federal Communications Commission (FCC) Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
007-0650-001 1