Advertisement
Modifications:
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC Responsible Party:
Siemens Subscriber Networks, Inc.
4849 Alpha Road
Dallas, TX 75244
Phone: 972-852-1000
Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
FCC Terminal Equipment Statements
This equipment complies with Part 68 of the FCC rules and the requirements adopted by
the ACTA. On the bottom side of this equipment is a label that contains, among other
information, a product identifier in the format US:AAAEQ##TXXXX.
number must be provided to the Telephone Company. A copy of the Suppliers Declaration
of Conformity to the FCC Part 68 and ACTA requirements can be found at:
http://www.part68.org.
This equipment has a Universal Service Order Code (USOC) of RJ11C, a Facility Interface
Code (FIC) of 02LS2, and a Service Order Code (SOC) of 7.0Y. The Telephone Company
may request this information when ordering service for this equipment.
A plug and jack used to connect this equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68 rules and requirements adopted by
the ACTA. A compliant telephone cord and modular plug is provided with this product. It is
designed to be connected to a compatible modular jack that is also compliant.
If this equipment causes harm to the telephone network, the telephone company will notify
you in advance that temporary discontinuance of service may be required. But if advance
notice isn't practical, the Telephone Company will notify the customer as soon as possible.
Also, you will be advised of your right to file a complaint with the FCC if you believe it is
necessary.
The Telephone Company may make changes to its facilities, equipment, operations or
procedures that could affect the operation of the equipment. If this happens the Telephone
007-0650-001
Safety and Certifications
This
If requested, this
2
Advertisement
