Removing A Dbm - Paradyne FrameSaver Installation Instructions Manual

Removing a DBM

1. Remove the screws and washers from the standoff posts that hold the DBM to the
NAM, and set them aside.
— For a BRI DBM, there are two sets of screws, washers, and standoff posts to
be removed.
— For a PRI DBM, there are three sets of screws, washers, and standoff posts to
be removed.
Pins
Connectors
2. Turn the NAM over and remove the screws and washers on the underside of the
NAM, and set the standoff posts, screws, and washers aside.
3. Turn the NAM over again so the DBM is on top.
4. Work the DBM away from the NAM by very carefully and gently pulling and rocking
the DBM connectors away from the NAM connectors. Work first from one side,
then the other until the DBM is free. Be careful not to bend any pins.
Screws/Washers
DBM
Standoff
Posts
Screws/Washers
5
98-15228a