Removing The Nam From Its Housing; Removing The Nam From A 1-Slot Housing - Paradyne FrameSaver Installation Instructions Manual

Removing the NAM from Its Housing

Select the appropriate procedure for removing the NAM from its housing. See page 4
if the NAM is in a multislot housing.

Removing the NAM from a 1-Slot Housing

1. Disconnect the power cord/transformer, first from the power outlet, then from the
rear of the FrameSaver unit.
2. Disconnect the other cables.
3. Using a small flat-blade
screwdriver, gently pry open
the housing at each of the
four connecting tab points.
Be careful not to damage
the housing (using a screw-
driver that is too big could
damage the housing.)
4. Remove the cover and lift
the NAM and its integrated
I/O card/ backplane (rear
panel) from the base.
5. Lay the NAM on an
electrostatic discharge-
protective work surface,
component side up, with
the card connectors on
the left-hand side.
NAM
3
98-15043a
Integrated
I/O Card/Backplane
Base
98-15044a