TRENDnet User's Guide
System
Set your system information
System > System Management
This section explains how to assign a name, location, and contact information for the
switch. This information helps in identifying each specific switch among other switches
in the same local area network. Entering this information is optional.
1. Log into your switch management page (see "Access your switch management page"
on page 6).
2. Click on System, and click on System Management.
3. Review the settings. When you have completed making changes, click Apply to save
the settings.
System Name ‐ Specifies a name for the switch, the name is optional and may
contain up to 15 characters.
System Location ‐ Specifies the location of the switch. The location is optional
and may contain up to 30 characters.
System Contact ‐ Specifies the name of the network administrator responsible
for managing the switch. This contact name is optional and may contain up to
30 characters.
4. Click Apply.
© Copyright 2018 TRENDnet. All Rights Reserved.
5. In the left hand panel, click on Save
6. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE‐TG82ES
8