Table of Contents
Advertisement
NELSON
HEAT TRACING SYSTEMS
™
PLT-BC
STANDARD POWER CONNECTION KIT
POWER CONNECTION
Terminal Block
Ground Wire
*Conduit & Drain; not included in kit
(must be positioned lower than the junction box)
Note: This detail shows Overjacket "J" or "JT" Products only. For Braided "CB" Product, see diagram
on sheet 1.
Place gasket on box adapter.
Position junction box on box adapter and secure it with the conduit locknut.
Connect bus wires, power wires and ground braid to the terminal block. See diagram above.
For Overjacket "J" or "JT" Products only:
Apply silicone at point braid leaves the overjacket
Push all wires, cable and terminal block inside junction box.
Place the box cover and box cover gasket onto the junction box.
Fill-in the voltage, catalog number & wattage blocks on the label with the actual field installed data.
Nelson Heat Tracing Systems products are supplied with a limited warranty. Complete Terms and Conditions may be found on Nelson's
website at
www.nelsonheaters.com.
P.O. BOX 726
TULSA, OK 74101
GA-1859 Rev. 6
Sheet 8 of 8
October 2006
Ground Braid
Power Termination
Power Leads
TEL 918-627-5530
FAX 918-641-7336
TERMINAL BLOCK CONNECTION
Ground
www.nelsonheaters.com
INSTALLATION
INSTRUCTIONS
Braid
Heater Cable
Advertisement
Table of Contents
