NELSON
HEAT TRACING SYSTEMS
™
PLT-BC
STANDARD POWER CONNECTION KIT
OVERJACKET PRODUCTS
127mm (5")
Lightly cut around heater overjacket 127mm (5")
from the end. Bend cable to break overjacket.
Lightly cut overjacket up the center between first
cut mark and the cable end. Bend cable to break
overjacket.
Remove overjacket from heater cable.
Move braid back toward the overjacket, creating
a bulge.
P.O. BOX 726
TULSA, OK 74101
GA-1859 Rev. 6
Sheet 4 of 8
October 2006
!
WARNING:
DO NOT CUT BRAID
TEL 918-627-5530
At the bulge, separate the braid to make an opening.
While bending the heater cable, work it through the
braid opening.
Pull the braid tight.
Proceed to "LT, CLT & HLT Products" on sheet 5.
FAX 918-641-7336
www.nelsonheaters.com
INSTALLATION
INSTRUCTIONS
114mm (4.5")