Table of Contents
Advertisement
NELSON
HEAT TRACING SYSTEMS
™
PLT-BC
STANDARD POWER CONNECTION KIT
SEALING GROMMET INSTALLATION FOR BRAIDED "CB" PRODUCTS
13mm (.5")
Slide braid back, allowing at least 13mm (.5") of
heater cable exposed.
Cut and remove the exposed heater cable.
BRAIDED "CB" PRODUCTS
127mm (.5")
Secure heater cable braid with fiberglass tape,
allowing 127mm (5") of cable for stripping.
Slide braid back towards the fiberglass tape creating
a bulge.
At the bulge, separate the braid to make an opening.
P.O. BOX 726
TULSA, OK 74101
TEL 918-627-5530
FAX 918-641-7336
Slide braid back over heater cable and twist excess
braid into a pigtail.
Slide the sealing grommet over the heater cable and
position inside stand-off opening.
Continue with step 5 on sheet 2.
Bend heater cable and work it through the braid
opening.
Pull the braid tight.
Proceed to "LT, CLT & HLT Products" on sheet 5.
www.nelsonheaters.com
INSTALLATION
INSTRUCTIONS
114mm (4.5")
GA-1859 Rev. 6
Sheet 3 of 8
October 2006
Advertisement
Table of Contents
