Flash Function; Ring Volume Switch; Lcd Backlight Function; Multifunction Handset - SPC 3606N RETRO ELEGANCE Manual

FLASH FUNCTION

When you dial a number but the line is busy, press FLASH key and then press RD key to dial it
out again.

RING VOLUME SWITCH

Slide the RING switch to HI (High), OFF according to your need.
NOTE: When slide to the OFF, there is no ring when the new coming.

LCD BACKLIGHT FUNCTION

The backlight will be turned on when receiving an incoming call, dialing, pressing any key or in
music hold mode, etc. It will fade off if the telephone is left idle for 6 seconds.
NOTE: If the battery is not installed, there will be no LCD backlight.

MULTIFUNCTION HANDSET

The handset can be used as earphone which is compatible with smartphones that has an audio
jack compatible with 3,5 mm jack of the type, then to away from radiation from smartphones.
The telephone can be used as only hands-free mode telephone when you unplug the handset.

TROUBLE SHOOTING

? No voice
+ Check if the handset is on the phone or line is broken.
? Receive only
+ Check if P/T mode is properly set.
? Noise
+ Check if the circuit is broken, change the circuit.
Check if the connector is moist or rust, change the connector.
? Ring once then disconnect when receive a call. Dialing function is available
+ Check if connector is in a moist environment.
Check if too many extensions are used together or the quality of extension is not good
enough, change the bad extension.
7