Predator VX360 Owner's Manual page 22

Attaching the Stick-on Mounting Pads to a helmet or other surface
The Predator VX360 is supplied with two self adhesive Mounting Pads. These are specifically for
enabling the user to attach the camera and mounting bracket to a helmet or other surface.
The pads use a high bond, water resistant adhesive to ensure a secure platform is created for the
mounting bracket. They are non corrosive, removable and safe for use on most surfaces, however
some helmet manufacturer warranties can be invalidated if the surface of the shell is altered in any
way so please check with your helmet manufacturer before attaching a patch. Predator
Technology Ltd is in no way liable for third party warranties that may be affected directly or
otherwise through the use of its products and accessories.
o Choose a suitable location for the camera and mount to be placed by placing the mount at
the desired location with camera to ensure the required camera angle can be obtained
o Place a pad with the peel-off strip intact onto the area to ensure there is sufficient area for
the pad to stick effectively
o Clean the area the pad is to be stuck too to remove any moisture, dirt or grease. This will
ensure that a much more secure bond is created.
o Remove the peel-off backing and place the pad onto the prepared area. Firmly push onto
the surface to increase the bonded strength
The camera and mounting bracket can now be attached to the helmet or surface and adjusted as
required.
Product Setup
Tip
When deciding on the best placement of
the camera and mount on a helmet
remember that the camera can rotate
360 degrees so you have a great
number of options. In our tests it has
been found that some of the most
watchable footage is obtained from the
top of the helmet.
22