Advertisement
TORQUE CHART
Tighten all screws, bolts, and nuts to their specified
torque values. Refer to the Service Manual for the torque
values of the removed parts.
Item
6 mm socket bolt
6 mm flange nut
8 mm socket bolt
INSTALLATION
CAUTION
• To prevent burns, allow the engine, exhaust system,
radiator, etc., to cool before installing the accessory.
NOTE:
• Take care not to damage the painted surfaces of the
motorcycle.
• Illustration shows NC700X type, other types are
similar.
1.
Install the left saddlebag hook and hook cover as
shown.
• Repeat on the right side.
REAR CARRIER
COLLAR B
6 mm
FLANGE
COLLAR A
NUT
6 mm WASHER
2. Refer to the Installation Instruction of the rear carrier,
install the rear carrier.
N·m
kgf·m
lbf·ft
10
1.0
7
12
1.2
9
24
2.4
18
LEFT
HOOK COVER
LEFT
SADDLEBAG
HOOK
2 of 3
3. Refer to the Service Manual for the motorcycle.
Remove the drive chain case.
BOLT
DRIVE CHAIN CASE
4. Work on the rear fender B as shown.
• Be careful not to damage the harness.
• Remove any burrs from the edge of the hole.
• Repeat on the right side.
SLIT
SIDE CUTTERS
Remove.
REAR FENDER B
FILE
File off the
cutout surface.
Advertisement
