Omega OM-CP-OM-CP-OCTPRO User Manual page 13

OM-CP-OCTPRO
USER INTERFACE
Factory Calibration
The OM-CP-OCTPRO comes with a complete Factory Calibration and provides users the ability to adjust the calibration settings per
channel, and roll back to the factory settings at any time. Note: For best performance and accuracy, Factory Calibration should be
performed at least once every 12 months.
Factory Calibration: Indicates the device is currently in
the factory calibrated state.
Channel Configuration Overview
An example of a completed channel configuration screen is shown below.
Apply Channel Configuration
Once channels are configured
as desired, the user must then
select Update to use those
settings.
A pop-up as shown to the
right will confirm that settings
have been applied.
User Calibration: Indicates the calibration settings have
been modified by the user.
• View Wiring Diagram: Shows how to properly wire
the device.
• Green Channel: Enabled channel.
• Orange Channel: Disabled channel.
• Linked Channels / Gray Channels: 3 or 4 wire RTD sensor
types can be selected for Channels 1, 3, 5 and 7. This
sensor type will also occupy the next sequential channel
and will be visually represented with a Link icon as seen
between Channels 3 and 4 on the screen to the left.
• Update: Once the user has configured the channel settings,
this button will apply the current settings to all channels.
• File: Loads previously saved configurations.
• Save: Saves the current Channel Configuration so it may
be loaded and used in the future.
• Disable All: Clears the programmed channels to disable all.
• Cancel: Cancels user changes and then goes back to the
Home screen.
Product User Guide | 12