Remote Control Unit - Sanyo RCS-SH80UA Instruction Manual

When you first turn on the ON/OFF operation button,
controller. During this blinking, the remote controller is verifying units connected. Use the remote
controller, after stops blinking.
G
L
K
D
P
H
1
A: When the unit is in the heating standby mode, the
Special Remarks on page 12.)
B: The currently selected operation mode is displayed.
C: This is displayed when a different operation mode was already selected by another remote control unit and
indicates that the mode cannot be changed.
D: When the TIMER SET button is pressed to set the timer, the
E: The currently selected FAN SPEED is displayed.
F: The currently selected Airflow Direction and SWEEP status are displayed.
G: This is displayed only when an abnormality occurs within a unit.
H: When the CHECK button is pressed, the TEST indicator appears.
I: This is displayed to indicate that the system controller is being used for control.
When
J: This indicates the indoor unit address in case of group control.
Unit No.
1 — 2
K: This is displayed when it is time to clean the filter.
L: When setting the timer, the selected timer mode is displayed.
M: This indication appears when the temperature is set.
N: This indication appears when the remote control sensor is used.
O: This indication appears when the ventilation fan does not operate even if the ventilation button has been
pressed.
P: This indication appears when the ventilation fan is operating.
1 - 8
Display (Remote Control Unit)
is flashing on the display, the operation is not accepted by the system controller.
Indoor unit No.
Refrigerant circuit No.
will blink on the display of the remote
B F C I
Description
indicator appears. (Refer to the description of the
indicator flashes.
J M
N
A
O
E
OI-432-01 - 8EG