Sanyo AHX0752 Service Manual page 112

1. Outdoor Unit Maintenance Remote Controller
Setting mode 2
Press the
button and the
ously for 4 seconds or longer.
Press the temperature setting
buttons to change the item code. The item codes
and setting data are shown in the table below.
Press the timer time
change the setting data.
To confirm the changed setting data, press the
(SET) button.
(At this time, the SET DATA display stops blinking
and remains lit.)
" " blinks when this mode is engaged, and
when this mode is engaged, "Now Setting" is dis-
played blinking, and the address of the outdoor
unit that is being set "System XX-YY" (System XX
= System address, YY = Outdoor unit address),
the item code No. (values from the table below),
1
1
and the corresponding settings data (6 digits) are
displayed. The item code number (values shown in
the table below) and the corresponding setting
data (6 digits) are also displayed. (The 6 digits of
the setting data are displayed by changing
2
2
between the first 3 digits (Fig. (C)) and the last
three digits (Fig. (D)). When the first 3 digits are
displayed, the top dot of the colon is illuminated.)
To exit setting mode, press the
button. Returns to normal display mode.
3
3
4
4
5
5
6
6
CODE
Parameter
7
NO.
7
Outdoor unit capacity 0 = Disabled
8
8
(CHECK) button, (SET)
(CANCEL) button simultane-
and
and buttons to
(CHECK)
280 (90 Type)
4
5
(C) Display of first 3 digits
(D) Display of last 3 digits
Refrigerant type: (C) and (D) are displayed alternately.
The example here (000, 410) indicates R410A.
Description (SET DATA)
112 (36 Type) 160 (60 Type)
450 (140 Type)
6-10
Service Checker
1
3 2