Table of Contents
Advertisement
Buttons
Button
Heat-up indicator
When you activate an oven function, the bars in
the display
come on one by one. The bars
show that the oven temperature increases or
decreases.
Steam Cooking
1. Set the function
2. Press the cover of the water drawer to open
it. Fill the water drawer with water until the
Tank Full indicator comes on.
The maximum capacity of the tank is 900
ml. It is sufficient for approximately 55 - 60
minutes of cooking.
Use only water as the liquid. Do
not use filtered (demineralised)
or distilled water. Do not use
other liquids.
Do not put flammable or
alcoholic liquids (grappa, whisky,
cognac, etc.) into the water
drawer.
3. Push the water drawer into its initial
position.
4. Prepare the food in the correct cookware.
5. Set the temperature between 130 °C and
230 °C.
Steam cooking does not give good results
in temperatures above 230 °C.
WARNING!
Wait a minimum of 60 minutes after
each use of the steam function in
order to prevent hot water from
exiting the water outlet valve.
Empty the water tank after the steam cooking is
completed.
CAUTION!
The appliance is hot. There is a risk
of burns. Be careful when you empty
the water drawer.
8
Function
MINUS
CLOCK
PLUS
.
Description
To set the time.
To set a clock function.
To set the time.
Water tank indicator
When the steam cooking operates, the display
shows water tank indicator. Water tank
indicator shows the level of the water in the
tank.
•
- Water tank is full. An acoustic signal
sounds when the tank is full. Press any
button to stop the acoustic signal.
•
- Water tank is half full.
•
- Water tank is empty. An acoustic
signal sounds when the tank must be refilled.
If you put too much water into the
tank, the safety outlet moves the
excess water to the bottom of the
oven.
Remove the water with a sponge or
a cloth.
Emptying the water tank
CAUTION!
Make sure that the appliance is cool
before you start to empty the water
tank.
1. Prepare the draining pipe (C), included in
the same package with the user manual. Put
the connector (B) onto one of the ends of
the draining pipe.
2. Put the second end of the draining pipe (C)
into a container. Put it at a lower position
than the outlet valve (A).
www.zanussi.com
Advertisement
Table of Contents
