Troubleshooting List; Service Addresses - Braun BASECut Aesculap XT407 Instructions For Use Manual

4.

Troubleshooting list

Malfunction
The blade set cannot be
fixed on hair clipper.
Stops during cutting
Upper blade vibrates.
Hair clipper doesn't charge. Wrong mains power cord
Blades do not move
5.

Service addresses

Albert Kerbl GmbH
Felizenzell 9
84428 Buchbach / Germany
Phone: +49 (0) 8086 933-100
Fax: +49 (0) 8086 933-500
E-Mail: info@kerbl.com
www.kerbl.com
Cause
The blade notch doesn't fit the
shaft properly.
Low power
Blade set is blunt.
Mains power cord not plugged in
completely.
Battery is comsumed/broken.
Low power
Battery is comsumed/broken.
Motor is broken.
Blade is not fixed properly.
Remedy
Pull small cutter back to center.
Connect hair clipper to mains power cord.
Replace blade set.
Contact distributor.
Replace mains power cord.
Plug in mains power cord completely into
DC socket 4 of the hair clipper.
Contact distributor.
Connect hair clipper to mains power cord.
Contact distributor.
Contact distributor.
Disassemble blade set and lock the blade
set again into position.
5