Advertisement
REMOVE
STEP
2
BATTERY
TABS
LEARN
AS LOW
STEP
TEMP
6
A
(40°F)
Open and close the case
to "tamper" the device
LEARN
AS HIGH
TEMP
STEP
6
(100°F)
B
Remove both of
the batteries
CONNECTS
Document#: IQTEMP-SQG-02-17
USING
Revision#: 2/2/18
Issue Date: FEB 2018
Qolsys Product #: QS5535-840
SECURE
319.5 MHz
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et
STEP
APPLY
3
ADHESIVE
Select "Freeze" as your sensor
type and customize settings as
Hold the tamper
button, insert the
*NOTE: Sensor Type "Freeze" (Sensor Group 52) is used for both Low Temp sensors and High Temp sensors. You can
batteries, release the
customize the Sensor Name to differentiate which one you are learning
tamper button
Qolsys Inc. proprietary.
Reproduction without permission is not permitted.
FCC ID: 2ABBZ-RF-CHW-S
IC: 11817A-RFCHWS
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
(2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
INSTALL IN
STEP
4
DESIRED
LOCATION
desired
LEARN
STEP
5
INTO
PANEL
Place your panel in
"autolearn" mode
Click "Add"
GOT QUESTIONS?
CONTACT TECH SUPPORT
TechSupport@Qolsys.com
Advertisement
