Subaru LEGACY 2003 Service Manual page 14

Engine section 1
Hide thumbs Also See for LEGACY 2003:
Table of Contents

Advertisement

COOLING
5
CHECK POWER SUPPLY TO SUB FAN RE-
LAY.
1) Turn ignition switch to OFF.
2) Remove sub fan relay from A/C relay
holder.
3) Measure voltage between sub fan relay ter-
minal and chassis ground.
Connector & terminal
(F28) No. 21 (+) — Chassis ground ( − − − − ):
Does the measured value exceed the spec-
ified value?
6
CHECK POWER SUPPLY TO SUB FAN RE-
LAY.
1) Turn ignition switch to ON.
2) Measure voltage between sub fan relay ter-
minal and chassis ground.
Connector & terminal
(F28) No. 24 (+) — Chassis ground ( − − − − ):
Does the measured value exceed the spec-
ified value?
7
CHECK 20 A FUSE.
1) Remove 20 A fuse from A/C relay holder.
2) Check condition of fuse.
Is the fuse blown-out?
8
CHECK POWER SUPPLY TO A/C RELAY
HOLDER 20 A FUSE TERMINAL.
Measure voltage of harness between A/C relay
holder 20 A fuse terminal and chassis ground.
Connector & terminal
(F27) No. 3 (+) — Chassis ground ( − − − − ):
Does the measured value exceed the specified
value?
9
CHECK FUSE.
1) Turn ignition switch to OFF.
2) Remove fuse No. 17 from joint box.
3) Check condition of fuse.
Is the fuse blown-out?
10
CHECK SUB FAN RELAY.
1) Turn ignition switch to OFF.
2) Measure resistance of sub fan relay.
Terminal
No. 20 — No. 21:
Does the measured value exceed the spec-
ified value?
11
CHECK SUB FAN RELAY.
1) Connect battery to terminals No. 22 and
No. 24 of sub fan relay.
2) Measure resistance of sub fan relay.
Terminal
No. 20 — No. 21:
Is the measured value less than the speci-
fied valve?
RADIATOR SUB FAN SYSTEM
Step
Value
10 V
10 V
Fuse is blown-out.
10 V
Fuse is blown-out.
1 MΩ
1 Ω
CO(H4SO)-12
Yes
Go to step 6.
Go to step 7.
Go to step 10.
Go to step 9.
Replace fuse.
Go to step 8.
Repair open circuit
Repair open circuit
in harness
in harness
between 20 A fuse
between main fuse
and sub fan relay
box connector and
terminal.
20 A fuse terminal.
Replace fuse.
Repair open circuit
in harness
between sub fan
relay and ignition
switch.
Go to step 11.
Replace sub fan
relay.
Go to step 12.
Replace sub fan
relay.
No

Advertisement

Table of Contents
loading

Table of Contents