Advertisement
RFRA - RF Room Thermostat
9. To connect the RFRA thermostat to the RF1 receiver
10. To disconnect the RFRA thermostat from the RF1
receiver
On the RF1 receiver
Press the reset button on the right side of the housing.
Within 2 seconds, press the connect button.
The RF1 receiver is now disconnected from the RFRA thermostat.
On the RFRA thermostat
Press the
button on the bottom of the thermostat, the front housing will
detach from the baseplate.
Press the RESET button on the printed circuit board.
"NO" will ash on the screen.
Rotate the hand wheel clockwise until "YES" appears on the screen.
Press the hand wheel once to con rm the setting.
The thermostat is now disconnected from the receiver.
EPH Controls Ireland
Sitecast Industrial Estate, Pouladu ,
Cork, T12 W665, Ireland
sales@ephcontrols.com www.ephcontrols.com
Page 2 of 2
Operating Instructions
EPH Controls UK
Unit E4, Welland Business Park, Valley Way, Market Harborough,
Leicestershire, LE16 7PS, United Kingdom
sales@ephcontrols.co.uk www.ephcontrols.co.uk
Advertisement
Need help?
Do you have a question about the RFRA and is the answer not in the manual?
Questions and answers
My EPH room thermostat is not shutting off when it reaches the set temp. How do I access the batteries to change them?
To access the batteries in an EPH Controls RFRA thermostat, press the button on the bottom of the thermostat. This will detach the front housing from the baseplate, allowing access to the battery compartment.
This answer is automatically generated