Installation Instructions; Electrical Connection - Blomberg DV 17600 W Owner's Manual

3

Installation Instructions

WARNING: Failure to follow
these instructions could result
in a risk of fire
•The clothes dryer ("appliance') installation
must be performed by a qualified installer.
•Install the appliance according to the
manufacturer's instructions and local codes.
•Do not install a clothes dryer with flexible
plastic venting materials. If flexible metal
(foil type) duct is installed, it must be of a
specific type identified by the ap pliance
manufacturer as suitable for use with clothes
dryers. Flexible venting materials are known
to collapse, be easily crushed, and trap lint.
These conditions will obstruct the clothes
dryer's airflow and increase the risk of fire.
SAVE THESE INSTRUCTIONS

3.1 Electrical connection

Connect the appliance to a grounded outlet
protected by a fuse or circuit breaker of
suitable capacity.
Dryer shipped with cord to fit this
type 4 -wire receptacle
4-wire r eceptacle
(14 -30R)
If yo u have 3-wir e recep tacle, like
this , a 3-wire dryer cord mu st be
purc hased locall y.
3-wire r eceptacle
(10 -30R)
Dryer / User Manual
C
Neutral conecction is not used in
this product
3-Wire Electrical Connection
If your receptacle is a 3-wire receptacle
as shown below, you must obtain a 3-wire
dryer cord. A dryer cord can usually be found
at your local hardware supply, electrical
supply or home center. Cord should have
closed loop or upturned end wire terminating
connectors. The cord kit must be marked
"For Use with Clothes Dryers".
3- wire receptacle
Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT
A
If the dryer is installed in a mobile
home, recreational vehicles, new
branch-circuit installations or in
areas where local codes do not
permit grounding through the
neutral conductor, only a 4-wire
power supply cord shall be used.
Power Cable
( 10-30R)
9 / EN