Table of Contents
Advertisement
3 Installation Instructions
A
WARNING!
Risk of fire
The clothes dryer ("appliance') installation
must be performed by a qualified installer.
Install the appliance according to the
manufacturer's instructions and local codes.
Do not install a clothes dryer with flexible
plastic venting materials. If flexible metal (foil
type) duct is installed, it must be of a specific
type identified by the ap pliance manufacturer
as suitable for use with clothes dryers. Flexible
venting materials are known to collapse, be
easily crushed, and trap lint. These conditions
will obstruct the clothes dryer's airflow and
increase the risk of fire.
To reduce the risk of severe injury or death,
follow all installation instructions.
3.1 Electrical connection
Connect the appliance to a grounded outlet
protected by a fuse or circuit breaker of
suitable capacity.
4-wire r eceptacle
(14 -30R)
3-wire r eceptacle
(10 -30R)
Dryer / User Manual
Dryer shipped with cord to fit this
type 4 -wire receptacle
If yo u have 3-wir e recep tacle, like
this , a 3-wire dryer cord mu st be
purc hased locall y.
C
NOTE
Neutral conecction is not used in this product
3-Wire Electrical Connection
If your receptacle is a 3-wire receptacle as
shown below, you must obtain a 3-wire dryer
cord. A dryer cord can usually be found at
your local hardware supply, electrical supply
or home center. Cord should have closed loop
or upturned end wire terminating connectors.
The cord kit must be marked "For Use with
Clothes Dryers".
3- wire receptacle
Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT
A
WARNING!
If the dryer is installed in a mobile home,
recreational vehicles, new branch-circuit
installations or in areas where local codes
do not permit grounding through the neutral
conductor, only a 4-wire power supply cord
shall be used.
Power Cable
( 10-30R)
11 / EN
Advertisement
Table of Contents
