Operation/Control - Mitsubishi FR-S520-0.1K to 3.7K(-R)(-C) Instruction Manual

4.

OPERATION/CONTROL

<Control panel>
The operation panel cannot be removed from the inverter.
RUN indication
Turns on/flickers* to indicate operation.
PU indication
Lit to indicate the PU
operation mode.
3-digit monitor LED
Shows the frequency,
parameter number, etc.
EXT indication
Lit to indicate the external
operation mode.
Setting dial
Used to change the frequency
setting and parameter values.
This dial cannot be removed.
*RUN indication On: Indicates that forward rotation operation is being performed.
Slow flickering (1.4 s cycle): Indicates reverse rotation.
Fast flickering (0.2 s cycle) : Indicates that operation is not
<Basic operation> (Factory setting)
Monitor/frequency setting
Return
MODE
Parameter setting
MODE
Alarm history
MODE
Press
MODE
key.
-
[Operation panel is used for operation]
PU
EXT
Press Turn setting
Press
PU/EXT dial to match
MODE
key. frequency.
key.
[Parameter setting change]
PU
EXT
Press
PU/EXT
Press key.
MODE
key.
Turn setting
dial to change
value.
PU/EXT key
Used to switch between the
PU and external operation
mode. (Change the Pr. 79
value to use the combined
RUN
PU
mode.)
PU
EXT
EXT
RUN key
RUN
+
Used to give the forward rotation
STOP
operation command. Use Pr. 17
RESET
to set reverse rotation.
MODE SET
STOP/RESET key
Used to stop operation
or reset an alarm.
SET key
Used to define each setting.
MODE key
Used to change the setting mode.
being performed but the
was pressed or the start command
was given.
SET
Press
SET
key.
Turn setting dial until
desired parameter
number appears.
After setting is complete,
SET
press
show alarm history,
Press SET key
to complete
or twice to show frequency
setting.
setting screen.
15
key
RUN
Frequency setting has
been written and
completed!!
and frequency flicker.
Press to start.
RUN
STOP
Press to stop.
RESET
SET
Press SET key to
show present setting.
key once to
MODE