Securing The Dwr-500 On Mast; Installing The Dwr-500 On Wall; Grounding The Dwr-500 - D-Link DWR-500 Quick Installation Manual

Securing the DWR-500 on Mast

This section covers the installation of the DWR-500 onto a vertical mast in a typical environment. Slide the
two anchor ear through the installation bracket as shown in Figure 13. Secure the DWR-500 onto the mast,
aligning the installation bracket to the mast and tightening the anchor ears around it.
Figure 13. Slide the anchor ear through installation bracket and mount on vertical pole

Installing the DWR-500 on Wall

The DWR-500 can also be mounted onto a wall instead of a
pole, by following these instructions. First, place the installation
bracket against the wall to mark out the four positions to drill for
the bolts. Proceed to drill into the four marked positions and
screw in the expansion bolts. Mount the DWR-500 and the
installation bracket onto the expansion bolts. Fasten the nuts to
secure the DWR-500 to the wall as shown in Figure 14.
Figure 14. Wall mounted DWR-500

Grounding the DWR-500

DWR-500 must be grounded before power up. Grounding wire resistance must be less than
5 ohm.
The DWR-500 must be grounded to prevent electrostatic
damage. The grounding terminal is at the side of the DWR-
500. The grounding cable is to be attached to the grounding
terminal on the DWR-500. First, secure the exposed end of the
grounding cable to the copper ring by running the exposed wire
through the copper ring and ensuring it is tightly wound. Next,
on the DWR-500 grounding terminal, loosen the screw and
place the copper ring through the grounding terminal, then
refasten the screw. Connect the other end of the grounding
cable to a grounding bar. Oil both the exposed ends of the
grounding cable. Once the grounding installation is completed,
it should appear as shown in Figure 15.
Figure 15. Grounding DWR-500.
DWR-500 Quick Installation Guide
7