Fujitsu AX SERIES Operating Manual page 7

Adjusting Air Flow Direction and Sweep
Angle
To direct air flow to center:
SUPER WAVE
ON
1
Vertical louver
Stop at the center
SUPER WAVE
3
OFF
SELECT LEVER
ON OFF
SELECT LEVER
1 Move the select lever fully left to the "NEUTRAL".
Position the vertical louvers approx. at the center and
2
move the select lever fully to the right end of the SUPER
WAVE ZONE.
Set the SUPER WAVE switch to "ON".
3
The vertical louvers start rotating with the maximum
sweep angle.
NOTE: If the MASTER CONTROL knob is set to "OFF",
set it to the other position.
4 The sweep angle can be adjusted within the SUPER WAVE
ZONE range. When the select lever is returned to the left,
the sweep angle decreases. Adjust sweep angle accord-
ing to preference.
NOTE: If the select lever is returned to the "NEUTRAL" in
2
error, the vertical louvers do not function properly.
In this event, carry out the procedure from the
beginning.
- 7 -