Brake System - RIEJU NUUK URBAN Owner's Manual

...for everyday adventure
Maintenance

Brake system

The Electric motorcycle NUUK has a combined braking system, in such a way that when the front brake is actuated, the braking will
be divided by 70% in the front brake and 30% in the rear brake. When the rear brake is actuated, only the rear brake will be
actuated.
The front and rear brake fluid tanks are located on the handlebars. To check the brake fluid level, place the bike in a horizontal
position and use the inspection glass of each liquid tank. The fill line must exceed the MIN mark located on each visor. As the pads
wear out the brake fluid level may drop.
The minimum wear level of the pads should not be less than 1.5 mm.
Check that the Disc is not grated or warped, and that the fixing screws are properly tightened.
Starter Battery
The bike features a 12v starter battery and 12Ah, which is located under the cover of the charger. To access it, loosen the 4 screws
on the corners of the cover and the screw located inside the charging cable compartment.
When the vehicle is turned on, the system uses the starter battery to start and activate the lights. When the vehicle's activation
sequence is carried out, the traction batteries go on to perform this function. In case of leaving the vehicle on and off, the lights will
drain the starter battery so that it cannot be activated.
The traction battery is recharged by the traction batteries if the voltage is lowered, as long as they are charged.
In case of excessive lowering of the voltage of the starter battery, charge independently of the vehicle or go to an authorised service
technician.
46