Mantenimiento; Dirt Cup Removal And Cleaning; Filter Cleaning; After Cleaning - Hoover Presto 2-in-1 Owner's Manual

3. Maintenance
Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped in water,
take it to a service center prior to continuing use.
NOTICE
!
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF.
2. Empty dirt cup.
3. Inspect the nozzle inlet, nozzle/dirt passage and filter for any obstructions. Clear obstructions
if present.
4. When cleaner is turned off and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.

dirt cup reMoVal and cleaninG

IMPORTANT
FOR BEST RESULT, CLEAN AFTER USE.
WARNING
! !
To reduce risk of personal injury - turn vacuum
off before servicing.
Press Hand Vac release button and remove Hand
Vac from Stick Vac.
3.1 Hold the handheld with the dust container
pointing downwards so that no dust will fall out
during opening. Push the release catch (A) on the
Hand Vac and pull the dust container (B) off the
motor unit (C).
3.2 Remove dust container from filter assembly and
cyclonic separator (3.2,D).
Hold the dust container over trash receptacle
and tap out debris (3.2,E).
3.3 Check cyclonic separator (F) for additional
debris and empty contents in trash receptacle
if needed. If this is not sufficient wipe the insides
of the cyclonic separator clean with a slightly
damp cloth.
Next, check the rinsable filter (G). If cleaning is
needed, refer to directions below for instruction
before dirt cup reassembly and replacement.

filter cleaninG

3.4 Remove rinsable filter made with HEPA media
(G), rinse with "a" side facing up in sink and allow filter
to COMPLETELY DRY for at least 24 hours before
replacing.
!
3.1 3.2
A
D
C
E
b
3.3 3.4 a
F
b
G

after cleaninG

After emptying debris from dust container and
cleaning filter if needed, re-assemble parts. Return
the filter onto cyclonic separator, insert back into
dust container and replace onto Hand Vac body/
motor housing and continue cleaning.
what to buy: rinsable filter
When used and maintained properly, your Rinsable
Filter should not need replacement within the
warranty period. If desired, additional filter is
available at Hoover.com or call 1-800-944-9200.
Ask for Hoover Part No. 440002094
®
9 Actual model may vary from images shown.