Table of Contents
Advertisement
Section 5
Install Idler Linkages and Linkage Motors
Step 1
Step 2
Enlarge this hole
in the welded
body flange to
3/8" diameter
2
3
Step 1
The Idler Linkage mounts toward the front of the
vehicle. Left (driver) side shown.
1 Enlarge the small hole as shown to 3/8" dia.
2 Mount the Idler Linkage behind the welded body
flange using 3 two #M8 -1.25x25 Button Head
Screws with #M8 Flat Washers.
4 Install one #M8-1.25x25 Button Head Screw
with #M8 Flat Washer through the bottom of the
Idler Linkage into the bottom of the vehicle body.
WARNING
Only tighten the screws
holding the Idler Linkages to the vehicle finger tight
at this time.
P9 - 75152 Rev. C 0416
Hardware
#M6-1.0 x 35
1
Socket Cap Screws
Part # 460.95
Qty. 3 per linkage
#M8-1.25 x 20
Button Head Screw
Part # 473.83
Qty. 2 per Linkage
#M8-1.25 x 25
4
Button Head Screw
Part # 522.95
Qty. 1 per Linkage
Installation Instructions - PowerBoard
Step 2
#M6 Flat Washer
Part # 481.96
Qty. 3 per linkage
Step 2
#M8 Flat Washer
Part #470.05
Qty. 3 per Linkage
Attach a Motor to each Motor Linkage using three
#M6-1.0x35 Socket Cap Screws, with three #M6
Flat Washers.
Left (Driver) side motor linkage shown above.
Repeat for Right (Passenger) side of the vehicle.
With the Motor-Linkage assembly near the vehicle
mounting position - underneath the rear of the
vehicle door opening - attach the wiring harness
motor connector to the motor.
Repeat on the Right (Passenger) side of the vehicle.
®
Page 9
Wiring harness
motor connector
Motor
Part #496.12
Motor Linkage - Left
Driver Side
Motor Linkage - Left
Part #525.19
Driver Side
Qty. 1
Part #517.89
Qty. 1
© 2016 Bestop, Inc.
Advertisement
Table of Contents
