Table of Contents
Advertisement
Section 9
Attach Boards and Lights
Step 1
Step 1
Attach the PowerBoard
to the linkages using two
®
#M6-1.0x20 Socket Cap Screws per linkage.
WARNING
Only tighten the screws
holding the Motor Linkages to the vehicle finger-
tight at this time.
P12 - 75152 Rev. C 0416
Hardware
#M6-1.0 x 20
Socket Cap Screw
Part # 470.00
Qty. 2 per Linkage
Light
Part #470.15
Qty. 2 per side
Installation Instructions - PowerBoard
Step 2
7" Cable Tie
Part #460.99
Black
Orange
Step 2
Clean the mounting surfaces with a 50/50 mix of
isopropyl alcohol and water.
Remove the adhesive liner from the bottom of the
light and firmly press it into the recessed area on
the motor linkage.
Plug the pigtail from the light into the connector on
the wiring harness with the orange and black wires.
Secure loose wires with the 7" Cable Ties as
necessary.
Driver side shown. Repeat on passenger side of
the vehicle.
®
Page 12
© 2016 Bestop, Inc.
Advertisement
Table of Contents
