Table of Contents
Advertisement
Section 7
Drill Holes for Motor Linkage Mounting
Step 1
Step 1
Using the #M8-1.25 x 20mm Button Head
Screw and the #M8-1.25 Hex Nut,
attach the supplied drilling template
#523.18 to the body flange, centering the
slotted template hole over the pre-existing
slotted hole in the welded body flange,
toward the rear fender.
Mark the position of the middle hole in the
template on the welded body flange.
Driver side shown.
P10 - 75152 Rev. C 0416
Hardware
#M8-1.25x20
Button Head Screw
Part #473.83
Qty.1
#M8-1.25
Hex Nut
Part #473.84
Qty.1
Drill Template
Part #523.18
Qty.1
Installation Instructions - PowerBoard
Step 2
1
Drill a 1/8" hole
using the template
2
Remove the template
and drill out the 1/8"
hole to 3/8"
Step 2
1 Drill a 1/8" hole in the welded body flange,
using the middle hole of the drilling template.
2 Remove the template, and drill out the
1/8" hole to 3/8".
Driver side shown. Repeat this process on the
passenger side of the vehicle.
®
Page 10
3/8" Drill
1/8" Drill
© 2016 Bestop, Inc.
Advertisement
Table of Contents
