Installing The Front - Pacific energy FP30 Arch Craftsman Installation Instructions Manual

Figure 14: FP30 Craftsman front damper clearance.
To install the front;
1. Align and place the air control lever through the opening in the lower section of the Front Assembly
(Figure 14).
2. Tilt the front up and under the Brow. Lift up and guide the side tabs into the corresponding openings
located in the side brackets. Push the Front Assembly into the slots, until it drops slightly - engaging the
mounting tab locks.
3. To lock the Front Assembly in place, install the four black #8 Torx screws provided into the holes located
behind the Front Assembly.
• In the door opening behind the Front, there are four screw holes. These may require the door to be
removed ( open door and lift up on hinge side) to see and access them clearly.
3
Figure 15: Openings for the front tabs and the position of the screws.
FP30 Arch Craftsman 240417-16

INSTALLING THE FRONT

2
12
5055.5154-A