Nemtek Druid LCD 2X Network Manual page 9

5 NEMTEK Ethernet Module Setup B
9. If the module is still configured as factory default, the following parameters should
be displayed (if the parameters differ, change the fields as shown in the figure):
10. If you are configuring a NemLink Ethernet Module connected to an energizer or
8-way Relay Board, and the device is installed on a local, private network, ONLY
"ModuleStaticIP"
the
be ignored).
11. If you are configuring a NemLink Ethernet Module connected to an FG7 or 8-way
Smart IO Board, and the device is installed on a local, private network, the
work mode"
needs to be changed to
need to be changed as explained in step 13 and 14.
12. Large, public networks, including routing and remote access via an internet
connection, are not covered by this guide. Please consult your network administrator.
"ModuleStaticIP"
13. Enter a new
a. Every NEMTEK network device needs to have a unique
address. Devices cannot share the same address.
b. It is recommended that the
192.168.0.1 to 192.168.0.254
needs to be changed as explained in step 13 (Step 14 can
"UDP".
adhering to the following criteria:
"ModuleStaticIP"
9
"ModuleStaticIP"
The
"ModuleStaticIP"
is chosen from the range
"Module
"RemoteIP"
and