Nemtek Druid LCD 2X Network Manual page 10

5 NEMTEK Ethernet Module Setup C
c. Ensure that all
means that for the range mentioned in (b.), the first 3 numbers (e.g. 192.168.0)
"ModuleStaticIP"
of the
devices and the last number may range from 1 to 254. An example of valid
"ModuleStaticIP"
i. NEMTEK NemLink (connected to NEMTEK FG7): 192.168.0.150
ii. NEMTEK NemLink (connected to Energizer): 192.168.0.100
iii. NEMTEK 8-way Relay Board: 192.168.0.55
iv. NEMTEK Smart IO Board: 192.168.0.200
"RemoteIP"
14. Enter a new
a. The NemLink connected to the FG7, must have a
the first three numbers are exactly the same as the first three numbers of all
the devices on the network and the last number is 255.
b. The NEMTEK Smart IO Board can only communicate with one energizer,
therefore the
energizer it communicates with.
c. With reference to the
the following is an example of valid
i. NEMTEK NemLink (connected to NEMTEK FG7): 192.168.0.255
ii. NEMTEK NemLink (connected to Energizer): not required
iii. NEMTEK 8-way Relay Board: not required
iv. NEMTEK Smart IO card: 192.168.0.100
"Save Config"
15. Click on
three times in the lower left dialog box if the changes were successful.
16. To check that the settings were saved successfully, click on the
button again. The changed network device IP address should appear in the dialog
"Search Device"
box above the
parameters were changed correctly.
17. Remove the jumper as mentioned in step 2 for the Taut Wire Node, NemLink and
Nemlink Network IO boards. Install the jumper on the 2 lower pins for the 8-way
Relay Board and 8-way Smart IO Board.
18. The network device is now ready for installation.
"ModuleStaticIP"
addresses are in the same IP range. This
address must be exactly the same for all network
addresses on the same network will be:
adhering to the following criteria:
"RemoteIP"
must be identical to the
"ModuleStaticIP"
to change the parameters on the module.
button. Click on this device and ensure that all
10
"Remote IP"
"ModuleStaticIP"
addresses in the example in step 13,
"RemoteIP"
addresses on the same network:
address where
of the
"ACK"
will appear
"Search Device"