Table of Contents
Advertisement
2000KL ASSEMBLY INSTRUCTIONS (CONTINUED)
29. Use the hexagon shoulder screws (III) to connect the two stretcher hoops to the load cell
beam assembly and securely tighten. Make sure that the stretcher hooks face each other in
the inward position, toward the stretcher canvas (see Figures 1 & 11).
30. Insert the stretcher bars into the stretcher channel pockets on either side of the stretcher
canvas. Confirm that the stretcher bars pass through the two hanging loops on each side of
the stretcher canvas.
31. Ensure that both ends of the channel pockets are sealed, by squeezing the Velcro strips
together (see Figure 11).
The hanging loops are tethered to the stretcher fabric. Make certain that each stretcher
Note:
bar passes through the hanging loops. The other portion of the hanging loop will go over
the hooks of the stretcher hoops.
32. The scale is now assembled. Plug the AC adapter into a power source and / or insert batteries
(see Figure 12).
10
Advertisement
Table of Contents
