Cleaning Evaporation Pan; Removing Scratches From Bumper - Hussmann MD-14 Installation & Operation Manual

M
4-4
aIntEnancE
M
4-4
aIntEnancE

CLEANING EVAPORATION PAN

(SELF CONTAINED ONLY)
The condensate water outlet for self
contained models empties into a limited
capacity evaporation pan.
Debris or dirt accumulation inside the condensate
evaporation pan or on the heater coil will
reduce the pan's evaporation capacity and
cause premature heater failure. The evaporation
pan waste water will overflow and spill onto the
floor if the heater is not properly operating.
Remove accumulated debris from the
evaporation pan. Wipe down heater coil with a
cloth and warm water. Be sure to remove any
dirt, debris or liquids from the heater coil.
Water introduced during cleaning will cause
the evaporation pan to overflow.
REMOVING SCRATCHES FROM
BUMPER
Most scratches and dings can be removed
using the following procedure.
1. Use steel wool to smooth out the surface
area of the bumper.
2. Clean area.
3. Apply vinyl or car wax and polish surface
for a smooth glossy finish.
P/N 2402646_H
P/N 2402646_G
and poses risk of bodily injury
and protective eye wear when servicing. Turn off
evaporation pan heater, and allow pan to cool.
U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
Evaporation Pan is Hot!
–
Always Wear gloves