Safety Instructions - B+B Sensors HM 1150 Instruction Manual

Digital quick-response thermometer
Table of Contents

Advertisement

INSTRUCTION MANUAL

Safety Instructions

Für Schäden, die durch Nichtbeachten dieser Sicherheitshinweise und der Bedienungsanleitung verursacht werden, übernimmt
die B+B Thermo-Technik GmbH keine Haftung.
This device has been designed and tested in accordance to the safety regulations for electronic devices.
However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and special safety
advises given in this manual will be adhered to when using it.
Trouble-free operation and reliability of the device can only be guaranteed if it is not subjected to any other climatic conditions
than those stated under "Specification".
If the device is transported from a cold to a warm environment condensation may result in a failure of the function. In such a
case make sure the device temperature has adjusted to the ambient temperature before trying a new start-up.
If device is to be connected to other devices the circuitry has to be designed most carefully. Internal connection in third party
devices (e.g. connection GND and earth) may result in not-permissible voltages impairing or destroying the device or another
device connected.
Warning:
Just devices with mains input: If device is operated with a defective mains power supply (e.g. short circuit from mains voltage to
output voltage) this may result in hazardous voltages at the device (e.g. at sensor socket)
If there is a risk whatsoever involved in running it, the device has to be switched off immediately and to be marked accordingly
to avoid re-starting. Operator safety may be a risk if:
● there is visible damage to the device
● the device is not working as specified
● the device has been stored under unsuitable conditions for a longer time
In case of doubt, please return device to manufacturer for repair or maintenance.
Caution:
Do not use these product as safety or emergency stop devices, or in any other application where failure of the product could
result in personal injury or material damage. Failure to comply with these instructions could result in death or serious injury and
material damage.
Technical changes reserved
B+B 0141 0315-117 September 2010
B+B Thermo-Technik GmbH | Heinrich-Hertz-Straße 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
05 / 12

Advertisement

Table of Contents
loading

Table of Contents