BellSouth MH9932 Installation Instructions & Owner's Manual page 16

Getting Started
5. Insert the small plug on the end of the AC ADAPTOR into the POWER-IN
connection jack on the back of the BASE UNIT.
6. Plug the AC ADAPTOR (output:12VAC, 500mA) into a 120V AC wall
outlet.
7. Set the date and time of the HANDSET and the BASE UNIT.
(For the HANDSET see page 33, for the BASE UNIT see page 37.)
8. Raise the antenna on the BASE UNIT for the best reception.
9. We recommend not placing this unit next to appliances. Doing so may
cause interference.
10. TONE/PULSE select switch:
A. If your home is equipped with a tone dialing system, set the TONE/PULSE
select switch to the TONE position.
B. If you have a rotary dialing system, set TONE/PULSE select switch to the
PULSE position.
C. If you are not sure which system you have, set the TONE/PULSE select
switch to the TONE position. Press the TALK button on the HANDSET
to get a dial tone, and press any button on the keypad except the zero. If the
dial tone continues, it means that you do not have tone dialing service.
Press the TALK button on the HANDSET to hang up. Set the TONE/
PULSE
11. Before initial use, charge the HANDSET for 12 hours.
You are now ready to use your new
select switch to the PULSE mode and then try again.
BellSouth Cordless Telephone.
16