Advertisement
D
Setup for an Existing Network Connection
If in case you have changed the Private Network Name of your
existing network, you may use the Simple Connect Button of your
HL129EP and the other devices as indicated below:
Step 1
HomePlug X
(Your new HomePlug AV2)
Press the Simple Connect button of your HomePlug
1
X for 10 SECONDS. After you release the button, the
Power
turn ON.
Step 2
HomePlug X
(Your new HomePlug AV2)
Press the Simple Connect Button of HomePlug AV Y for
TWO SECONDS. The Power LED
If the Power LED did not blink, press the Simple Connect
button again for two seconds.
HomePlug Y
(A HomePlug that
belongs to the existing
network)
and the Ethernet LED
will turn OFF and
HomePlug Y
(A HomePlug that
belongs to the existing
network)
2
will continuously blink.
MODEL
HL129EP
Step 3
HomePlug X
(Your new HomePlug AV2)
3
Step 4
HomePlug X
(Your new HomePlug AV2)
To confirm if the connection has established, check the LEDs. The Power LEDs
4
and the Powerline Activity LEDs on all HomePlugs would be ON.
Press for 3 SECONDS
to perform factory
defaul reset.
HomePlug Y
(A HomePlug that
belongs to the existing
network)
Within two minutes, press the simple connect button of
HomePlug X for TWO SECONDS.
HomePlug Y
(A HomePlug that
belongs to the existing
network)
NOTES:
• When joining an existing network, you only have
to pair it to one HomePlug AV that belongs to the
existing network.
• The Ethernet Activity LED
will only be lit if it is
connected to an Ethernet device (e.g. computer,
laptop, etc) through an Ethernet cable.
• To perform RESET to factory defaults, press the reset
button for 3 SECONDS.
Advertisement
