Mira Eco Installation And User Manual page 7

9. Loosely attach the RAC backplate to the RAC
wallplate, using the two backplate screws
provided.
10. Place the RAC backplate/wallplate assembly
over the outlet pipe with the arrow pointing
vertically up. The screw holes should be at
40° to the horizontal.
11. Mark the positions of the two RAC wallplate
fixing holes.
Wallplate
40°
RAC Backplate
Backplate Screws
11. Remove the assembly from the wall and
separate the backplate from the wallplate.
12. For solid walls drill two 6 mm holes for the
wall plugs. For other types of wall structure
alternative fixings may be required (not
supplied). If necessary, make a recess 6 mm
deep to accept the wallplate for flush fitting of
the outlet to the wall surface.
Caution! Make sure that you do not drill into
pipework in the wall.
13. Fit the two wall plugs supplied and secure
the wallplate to the wall with the two wallplate
screws.
14. Make sure that there is clearance behind the
wallplate and temporarily fit the two backplate
screws into the wallplate. This will prevent
the fixing holes from becoming blocked with
plaster or grout.
15. Finish the wall, e.g. tiles. then remove the two
backplate screws.
Important! Refer to your shower control
installation and user guide.
Caution! Make sure that the finished wall
is within the maximum and minimum limits
and to an even depth (no greater than 2 mm
variation).
Arrow
16. Place the backplate over the outlet pipe with
the arrow pointing vertically up and tighten the
two backplate screws. Make sure that the foam
seal abuts the finished wall surface.
17. Check that the blue 'O' seal is fitted inside the
backplate nut. Fit the olive and the backplate
nut over the outlet pipe and tighten the nut.
18. Check that the second 'O' seal (black) is fitted
to the outside of the backplate nut. Press
the elbow onto the backplate, make sure
that the clips on the elbow engage with the
backplate.
19. Press the shroud over the elbow, make
sure that it engages with the lugs on the
backplate.
20. This completes the installation of the RAC
assembly, continue with the installation of the
EV Shower Fittings.
7
RAC Backplate
Backplate
Screws
Olive
Backplate Nut
Elbow
Shroud