Group (Tab)
Print Test Sheet
button
Registration
Adjustment
Tray 2
Horizontal
Adjustment
Vertical
Print Test Sheet
button
Registration
Bypass Tray
Adjustment
Vertical
Color
Adjust button
Registration
FW Update
FW update
button
button
"*" indicates the factory default value.
Item
Selections
(-15 to +15)
step
(-15 to +15)
step
(-15 to +15)
step
Remarks
Sends a command to the printer to print a test
sheet.
It is disabled when tray 2 is not installed.
0.34 mm per step. Range is -5 mm to +5 mm.
If the machine settings are reset to the factory
defaults, this value does not change.
0.24 mm per step. Range is -3.6 mm to +3.6 mm
If the machine settings are reset to the factory
defaults, this value does not change.
Sends a command to printer to print a test sheet.
0.24 mm per step. Range is -3.6 mm to +3.6 mm
The engine will do color registration and density
tuning automatically.
The printer will warm up automatically after this
setting is changed.
The "color registration" in User Tools includes
only a "Fine Adjustment". In service support,
never fail to use SP mode 2 including both fine
and rough adjustment.
This button is for updating the controller firmware.
The button for updating the engine firmware is
located in the "SP Mode 1" tab.
Smart Organizing Monitor
4
31