Version Display In The Setup Menu - Denon AVR-X6400H Service Manual

1.5. Version Display in the Setup Menu

Follow the steps below to display the firmware information.
(1) Press the "SETUP" button on the remote control.
(2) Select "General - Information - Firmware".
The version information is displayed as a 16-digit number as shown in the screenshot below.
General/Firmware
Version
XXXX-XXXX-XXXX-XXXX
-DTS Version
X.XX.XX.XX
GUI Image
This 16-digit number comprises a part of the version number of each device and module.
Numerics and version numbers correspond as shown below.
The 6th digit from the right for Main
The 5th digit from the right for Main
The 2nd digit from the right for Main
The 1st digit from the right for Main
Main X X X X X X 1 5 X X 3 4
DSP1 X X X 2
The 1st digit from the right for DSP1
DSP2 X X X 4
The 1st digit from the right for DSP2
DSP3
X X X 6
The 1st digit from the right for DSP3
DSP4
X X X 8 The 1st digit from the right for DSP4
A.PLD X X X 1
The 1st digit from the right for A.PLD
V.PLD X X X 5
The 1st digit from the right for V.PLD
GUI
X X X X X X 1 6
The 1st digit from the right for GUI
LEGO Version X . 3 6 7 . 1 3 X
b The firmware version numbers and this 16-digit version information are written in the Service Information.
b Replace as follows for the 5th to 7th digits of HEOS version.
X.XXX.X → X.XXX.00X
X.XXX.XX → X.XXX.0XX
X.XXX.XXX → X.XXX.XXX
1 2 4 6 - 5 1 4 3 - 6 5 3 1 - 7 8 6 3
Info display
The 2nd digit from the right for HEOS
The 3rd digit from the right for HEOS
The 4th digit from the right for HEOS
The 5th digit from the right for HEOS
The 6th digit from the right for HEOS
146