Utc220Xlt Command Set - Bematech PDX3000 User Manual

8.1.7 UTC220XLT Command Set

1. Top line Alphanumeric <1B> <75> <41> Data <0D>
The leftmost 20 characters, following the command terminated by a <0D> (Carriage
Return) will be displayed on the top line.
To clear top line use: <1B> <75> <41> <0D>.
This command is only effective on pass-through mode.
2. Bottom line Alphanumeric <1B> <75> <42> Data <0D>
The leftmost 20 characters, following the command terminated by a CR (Carriage Return)
will be displayed on the bottom line.
To clear bottom line use: <1B> <75> <42> <0D>.
This command is only effective on pass-through mode.
3. Top Line Ongoing Message Scroll <1B> <75> <44> Data <0D>
A message of up to 40 characters will be scrolled continuously on the top line of the
display.
This command is only effective on pass-through mode.
4. Time Display Bottom Line <1B> <75> <45> hh:mm <0D>
Time value (12 hour clock) will be shown on the bottom line in the format { hh:mm:ss }
and continuously updated until cleared by a command to write to the bottom line.
To re-display previously set time use: <1B> <75> <45> <0D>
This command is only effective on pass-through mode.
5. Top Line 1 Time Message Scroll <1B> <75> <46> Data <0D>
A message of up to 40 characters will scroll once on the top line.
This command is only effective on pass-through mode.
6. Back Spacing <08>
Move cursor position to the left one position, erasing the character, if any, that was in that
position.
7. Horizontal Tab <09>
Horizontal tab.
8. Line Feed <0A>
Line feed.
9. Carriage Return <0D>
Move cursor to the first position of the current line.
10. Display Position <10> <n>
Move the cursor to any position on the display. "n" is the digit position where the cursor
is to be moved to.
11. Normal Display Mode <11>
After writing a character, the cursor is shifted automatically to the right one position.
32