Table of Contents
Advertisement
Operating Your Camera
SYNC : Two synchronization modes are available INTERNAL and EXTERNAL LINE-LOCK.
In LINE-LOCK mode, it synchronizes the camera's video out signal to the external
SYNC signal.
SPECIAL SETUP
USER PRESET
PRIVACY
DAY/NIGHT
SYNC
COMM ADJ
IMAGE ADJ
•INT : Internal synchronization
•LL : External line-lock synchronization
· If you choose 'LL', you can adjust the desired phase.
Press the SET button.
· You can adjust the desired phase from 0 to 359.
Notes
• For NTSC models, the line-lock mode can be used if the external SYNC signal
frequency is at 60Hz.
• For PAL models, the line-lock mode can be used if the external SYNC signal
frequency is at 50Hz.
COMM ADJ: Use this feature to select communication
protocol . Position the indicator over
'COMMUNICATION' using the UP or
DOWN button.
40
COLOR CCD CAMERA
User's Manual
OFF
OFF
COLOR
INT
•CAM ID : Assign ID number to the camera. It is restricted available to set ID from
1 to 255.
•DISP CAM ID: Displays camera ID on top left corner of the screen.
•BAUD RATE : Configure baud rate from 9600, 19200, 38400, 57600bps.
•UART MODE : Configure parity bit to NONE, EVEN, or ODD. Data bit is set to 8bit,
and stop bit to 1bit. Set the UART MODE to EVEN if using the
Remote Controller.
•RET PKT
: Used to transfer a packet.
•END
IMAGE ADJ: Includes image quality or special function
factors.
•FREEZE: Use this feature to freeze capture an image.
•H-REV: Use this feature to horizontally inverse the screen.
•V-REV: Use this feature to vertically inverse the screen.
•SHARPNESS : Increasing this value sharpens object edges. Too high of a setting,
however, produces noise and may obscure the image.
•COLOR AGAIN : Adjusting this value affects the chroma level only; the burst level is
unaffected.
END: evert back to the USER PRESET menu.
RESET
To reset your camera to factory default condition.
EXIT
To finish setup menu.
COLOR CCD CAMERA
41
User's Manual
Advertisement
Table of Contents
