Table of Contents
Advertisement
Connection
Connecting to Monitor
Connect the VIDEO-OUT jack to the VIDEO-IN jack of monitor.
CCTV Camera
• As the connecting method varies with the instruments, refer to the manual
supplied with the instrument.
• If necessary, you can connect the monitor to the REMOTE jack on the back of
your camera.
• Only connect the cable when the power is turned off.
• Set the 75Ω / Hi-Z selection switch as shown below if you have an intermediate
device.
CCTV Camera
16
COLOR CCD CAMERA
Monitor
Intermediate
End monitor
User's Manual
Connecting to Power
Connect the adaptor to the power input connector as shown in the figure
below. The recommended adaptor specification for SID-500N/SID-500P is AC
24V / 500mA or DC 12V / 500mA.
When the resistance value of copper wire is at [20°C(68°F)]
2
Copper wire size (AWG)
#24(0.22mm
)
#22(0.33mm
Resistance (Ω / m)
0.078
Voltage Drop (V/m)
0.028
•As shown in the table above, voltage decreases as the wire gets longer.
Therefore use of an excessively long adaptor output line for connection to the
camera may affect the performance of the camera.
*Standard voltage for camera operation : DC 12V ± 10%
*There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
Notes
• Be sure to connect power only after all the installation is complete.
• Note that AC or DC adaptor is not supplied with camera.
• Use the UL listed, class 2 power transformer of AC 24V adaptor.
• Ground should be connected to the GND terminal.
COLOR CCD CAMERA
2
2
2
)
#20(0.52mm
)
#18(0.83mm
)
0.050
0.030
0.018
0.018
0.011
0.006
17
User's Manual
Advertisement
Table of Contents
